Iteration

Iteration Build Logs

• Swole Bar - 12lb Beater Bar
• Iteration Weapon Pulley and Belt
• Iteration Weapon Motor Mount and Cross Member
• Frame Post Operations and Jigs
• Iteration Frame Assembly
• Iteration Drive Assembly
• Iteration Titanium Panel Post Processing
• Rev Robotics Printed Wheel Hub
• Longbox Modifications

Iteration Fight Logs

• Iteration vs Pramheda
• Iteration vs Deevee
• Swole vs Aerostar
• Swole vs Blue Cheese

Drivetrain

• 4” Rev robotics wheel
• Printed TPU wheel hub with integrated pulley, 24 tooth
• Nylon Bushings
• 0.5” aluminum dead shaft
• HTD 5mm - 9mm Width, 225mm Pitch Length, 45 Tooth
• 16 tooth gearbox pulley
• Modified long box 20:1 gearbox
• Innovative Design BA2320-1860KV Brushless Motor
• Lumineer 51A ESC

Weapon

• Swole Bar
• 1/2”-13 Flathead bolt impactors
• 0.5” needle roller bearings
• 0.5” 1566 carbon steel shaft
• Needle-roller thrust bearings and washers
• Aluminum shaft collars for shaft retainment
• 2” 2L weapon pulley
• 2L x 12 inch cogged v belt
• 1” 2L motor pulley
• 3665-1800KV Brushless Inrunner Motor
• Gobilda 36mm Clamping Mounts
• Tempest 120A ESC

Electronics

• MS-05 Power Switch
• 6s 1550mAh Lipo
• FS2A Reciever
• Ring terminals for primary power distribution
• Low profile M5 bolts and nyloc nuts for affixing ring terminals

Frame

• 0.75” UHMW weapon side rails
• 0.5” UHMW weapon cross member
• 0.5” UHMW rear panel
• 0.1” Titanium top and bottom panel
• #10 x 1” plastite screws for affixing top and bottom panels to UHMW frame
• #10 x 1.5” plastite screws for affixing weapon side rails to cross member and rear panel
• 2mm Carbon Fiber plates for mounting gearboxes to side rails
• TPU Wheel Guards
• 0.5” aluminum tubes for retaining armor
• TPU Forks / Weapon Retain Collar Covers