Iteration Vs Pramheda

Iteration vs Pramheda

Ko’d Via receiver dying
Gifted weapon, wpn pulley, and wpn shaft to Zack
55 Minutes of casual work to get bot back to fighting state, took a bit longer to trouble shoot dead FS2A
43% Battery used

43% Battery Used

Isolate receiver from primary systems
Further tune the drive system
Practice drive more
Learn to gyro flip when inverted
Consider removing wheel guards or changing ground clearance, can’t get hung up on the wall like that
More drive coaching during the match
Weapon on weapon contact with thin bladed vertical spinners while one of the bots is inverted is not advised
Need to have adjustable weapon speeds during the match, once after the initial couple of hits more control of drive would of been good.
TPU wheel guards need to protect the armor retainment pins better
TPU wheel guards should be thicker for thin verts, doesn’t need to be anymore dense though, maintain the weight, but just thicker.
Consider mounting the armor with bolts and standoffs instead of spacers and C clips
Battery may need to be larger, unsure with how short the fight was and how fast the weapon was spinning the whole time.

KO Reason - FS2A died at the hands of the weapon BEC
Bent weapon bar and weapon shaft on inverted weapon on weapon contact
Rear armor mount and left wheel guard damaged on free hit while stuck on wall
Weapon pulley and belt took a direct hit early on and kept working despite a sizable chunk being removed and a screw being sheered

Torn side armor, all top armor retaining clips are gone, but armor pins stayed in

2 Stripped screw holes on left side, center screw was already missing so this may have lead to this

Left wheel hit and torn armor mount

Torn armor mount

Sheered Weapon Pulley Screw