Revision Repeat MK3 Setup

This is the process I use to shorten the wires and add the bullet connectors to Revision’s drive motors. The motor side connector is a 2mm Male Bullet Connector with 10mm of 2.5-1.25mm Heat Shrink Tubing over each of the phase wires.

Trim MK3 motor phase wires to 35mm from motor can

Strip 2mm from the phase wires and tin the tips

Apply solder to male 2mm bullet connector

Grip bullet connector with tweezer and apply heat to outer casing near the solder. Slip over wire, remove heat, and hold until solder has solidified.

Cut 10mm of 2.5-1.25 heat shrink tubing. Align with the bullet connector and apply heat. Do this individually to reduce possibility of errors.